Ústav technické a experimentální fyziky Institute of Experimental and Applied Physics

Measurement of dijet cross-sections in pp collisions at 7 TeV centre-of-mass energy using the ATLAS detector

NázevTitle
Measurement of dijet cross-sections in pp collisions at 7 TeV centre-of-mass energy using the ATLAS detectorMeasurement of dijet cross-sections in pp collisions at 7 TeV centre-of-mass energy using the ATLAS detector
Druh výsledkuResult type
Článek v časopiseJournal article
AutořiAuthors
G. Aad, T. Abajyan, B. Abbott, S.A. Khalek, O. Abdinov, K. Augsten, P. Gallus, J. Günther, J. Jakůbek, Z. Kohout, V. Král, S. Pospíšil, F. Seifert, V. Šimák, T. Slavíček, K. Smolek, J. Sodomka, M. Solar, J. Šolc, B. Sopko, V. Sopko, I. Štekl, D. Tureček, M. Vlasák, P. Vokáč, Z. Vykydal, M. Suk
DOIDOI
10.1007/JHEP05(2014)059
Časopis / citaceJournal / citation
JOURNAL OF HIGH ENERGY PHYSICS. 2014,(5), 1-66. ISSN 1029-8479.
RokYear
2014
JazykLanguage
eng
WoSWoS
000336740400001
ScopusScopus
2-s2.0-84925759768
RIVRIV
RIV/68407700:21110/14:00225786!RIV15-MSM-21110___
ProjektProject
Mezinárodní experiment ATLAS-CERNInternational Experiment ATLAS-CERN; Mezinárodní experiment ATLAS-CERNInternational experiment ATLAS-CERN; Podpora zkvalitnění týmů výzkumu a vývoje a rozvoj intersektorální mobility na ČVUT v PrazeSupport of inter-sectoral mobility and quality enhancement of research teams at Czech Technical University in Prague

AbstraktAbstract

Double-differential dijet cross-sections measured in pp collisions at the LHC with a 7 TeV centre-of-mass energy are presented as functions of dijet mass and half the rapidity separation of the two highest-p(T) jets. These measurements are obtained using data corresponding to an integrated luminosity of 4.5 fb(-1), recorded by the ATLAS detector in 2011. The data are corrected for detector effects so that cross-sections are presented at the particle level. Cross-sections are measured up to 5 TeV dijet mass using jets reconstructed with the anti-k(t) algorithm for values of the jet radius parameter of 0.4 and 0.6. The cross-sections are compared with next-to-leading-order perturbative QCD calculations by NLOJet++ corrected to account for non-perturbative effects. Comparisons with POWHEG predictions, using a next-to-leading-order matrix element calculation interfaced to a parton-shower Monte Carlo simulation, are also shown. Electroweak effects are accounted for in both cases. The quantitative comparison of data and theoretical predictions obtained using various parameterizations of the parton distribution functions is performed using a frequentist method. In general, good agreement with data is observed for the NLOJet++ theoretical predictions when using the CT10, NNPDF2.1 and MSTW 2008 PDF sets. Disagreement is observed when using the ABM11 and HERAPDF1.5 PDF sets for some ranges of dijet mass and half the rapidity separation. An example setting a lower limit on the compositeness scale for a model of contact interactions is presented, showing that the unfolded results can be used to constrain contributions to dijet production beyond that predicted by the Standard Model.

Double-differential dijet cross-sections measured in pp collisions at the LHC with a 7 TeV centre-of-mass energy are presented as functions of dijet mass and half the rapidity separation of the two highest-p(T) jets. These measurements are obtained using data corresponding to an integrated luminosity of 4.5 fb(-1), recorded by the ATLAS detector in 2011. The data are corrected for detector effects so that cross-sections are presented at the particle level. Cross-sections are measured up to 5 TeV dijet mass using jets reconstructed with the anti-k(t) algorithm for values of the jet radius parameter of 0.4 and 0.6. The cross-sections are compared with next-to-leading-order perturbative QCD calculations by NLOJet++ corrected to account for non-perturbative effects. Comparisons with POWHEG predictions, using a next-to-leading-order matrix element calculation interfaced to a parton-shower Monte Carlo simulation, are also shown. Electroweak effects are accounted for in both cases. The quantitative comparison of data and theoretical predictions obtained using various parameterizations of the parton distribution functions is performed using a frequentist method. In general, good agreement with data is observed for the NLOJet++ theoretical predictions when using the CT10, NNPDF2.1 and MSTW 2008 PDF sets. Disagreement is observed when using the ABM11 and HERAPDF1.5 PDF sets for some ranges of dijet mass and half the rapidity separation. An example setting a lower limit on the compositeness scale for a model of contact interactions is presented, showing that the unfolded results can be used to constrain contributions to dijet production beyond that predicted by the Standard Model.