Metal grain structure resolved with table-top micro-tomographic system
- NázevTitle
- Metal grain structure resolved with table-top micro-tomographic systemMetal grain structure resolved with table-top micro-tomographic system
- Druh výsledkuResult type
- Článek v časopiseJournal article
- AutořiAuthors
- D. Vavřík, P. Soukup
- DOIDOI
- 10.1088/1748-0221/6/11/C11034
- Časopis / citaceJournal / citation
- Journal of Instrumentation. 2011, 6(C11034), 1-7. ISSN 1748-0221.
- RokYear
- 2011
- JazykLanguage
- eng
- WoSWoS
- 000298320400034
- ScopusScopus
- 2-s2.0-83055195128
- RIVRIV
- RIV/68407700:21670/11:00191592!RIV12-MSM-21670___
- ProjektProject
- Využití radionuklidů a ionizujícího zářeníApplication of radionuclides and ionising radiation; Vyhodnocování energie odpovědné za růst trhlinyEvaluation of the energy responsible for fracture advancing
AbstraktAbstract
X-ray transmission radiograms of Aluminum alloy contain relatively low contrast features induced by variations of the material chemical composition. Generally, these variations are strongly connected with grains of the metal, where these differ from each to other. Although grains of the studied material have typically dimensions of tens of micrometers only, the material variations can enable the observation of geometry and orientations of grains in the specimen volume employing advanced X-ray micro tomographic method. Analysis of such tiny structures requires high dynamic range of acquired radiograms with high signal to noise ratio and appropriate geometrical magnification. These requirements can be fully satisfied by using the pixelated single photon counting device Medipix, a precise micro-tomographic setup and appropriate data processing. Results will be demonstrated with an Aluminum alloy bar specimen.
X-ray transmission radiograms of Aluminum alloy contain relatively low contrast features induced by variations of the material chemical composition. Generally, these variations are strongly connected with grains of the metal, where these differ from each to other. Although grains of the studied material have typically dimensions of tens of micrometers only, the material variations can enable the observation of geometry and orientations of grains in the specimen volume employing advanced X-ray micro tomographic method. Analysis of such tiny structures requires high dynamic range of acquired radiograms with high signal to noise ratio and appropriate geometrical magnification. These requirements can be fully satisfied by using the pixelated single photon counting device Medipix, a precise micro-tomographic setup and appropriate data processing. Results will be demonstrated with an Aluminum alloy bar specimen.